製品ニュース

Because the print head is not sealed tightly after normal printing or is left for a long time, the water evaporates excessively, causing the ink particles to dry on the fine tip of the print head, making the ink unable to spray normally; or different inks are mixed with each other, resulting in chemical reactions, which usually manifest as frequent line breaks, color loss, blurred handwriting, or even failure to print normally.

The OPC（Organic Photoconductor）is the photosensitive drum, which is the core component of the laser printer. It is generally not sticky with toner. If there is toner on the drum core, it should be cleaned in time. The possible reasons why the drum core is sticky with toner are: 1. There are sticky substances such as grease on the drum core: wipe the OPC（Organic Photoconductor）with a clean soft cloth. 2. The toner is not added properly: Pay attention to the method when adding toner, and you can use printing paper to pad the toner cartridge mouth. 3. The toner quality is poor: Replace with high-quality toner. 4. The waste toner scraper […]

Toner powder are not universal. The universality of toner powder depends on multiple factors, including electrical properties, magnetism, etc. Specifically： Electrical properties: The electrical properties of toner powder must be consistent. Magnetic properties: Magnetic powder can barely replace non-magnetic powder, but non-magnetic powder can never replace magnetic powder.

1. Clean the toner cartridge chip If the printer does not correctly detect the toner cartridge, it will prompt "Consumables remaining error". You can remove the toner cartridge and use a clean cotton swab or paper towel to clean the toner cartridge chip 2. Reinstall the toner cartridge If the toner cartridge is not installed in the correct position, it will prompt "Consumables remaining error", so you need to reinstall the toner cartridge.

1. Vertical black lines of more than 1 cm in width appear on both the printed document and the drum core: This is a problem with the scraper, which causes the powder on the stick core to not be scraped cleanly. 2. Vertical thin black lines appear on the printed document: Usually the scraper and the small scraper on the edge of the scraper are stuck with dirt or paper scraps. 3. Horizontal black lines appear on the printed document: Usually the magnetic stick in the toner cartridge has accumulated powder, just turn it a few times. 4. If there is obvious bottom ash on the printed document: Usually there […]

From the cost point of view, the cost of adding toner to the toner cartridge is much lower than that of replacing the toner cartridge, so adding toner is more cost-effective. However, from the actual use, since the toner cartridge is a sealed disposable consumable, adding toner by yourself will destroy the sealing performance of the toner cartridge and cause toner leakage. Therefore, the toner cartridge cannot be added too many times. Under normal circumstances, the toner cartridge can be added about 2-3 times (different toner cartridges also have differences) In summary, when the printer toner is used up, you can add toner 2-3 times and then replace the toner […]